Paper bead rose necklace DIY

I was cleaning out magazines the other day and thought ‘Wouldnt it be great if I could reduce junk and at the same time create a piece of jewelry without spending anything?’ and that thought led me to making this cute necklace with glossy magazine paper beads and a punch based rose. Do try it out!!

Paper bead rose necklace DIY

Materials:
– 1 glossy magazine sheet or any paper
– toothpick/quilling needle 
Modpodge
– flower punch
– 6 gray pearls
– 3 white pearls+ 1 bead
– jump rings
– eyepins
round nose pliers
– wire cutter 
– chain
– clasp 

Method:

Make the beads
1) Cut the paper into 4 isosceles triangles of 3cm width and one of 1.75cm width.
2) roll them with a toothpick into beads(the 3cm width ones should be rolled into bi cones and the normaler one into a cone). To roll into a cone keep the pointy end of the triangle on one end of the toothpick while rolling and in the center to get a bicone
3) put into an eyepin and loop. Repeat five times. (ignore the extra bead in the how to visual)
4) Seal the beads with a sealant. I used modpodge (2 coats)

 
Make the Flower
1) I used a flower punch that I used to make my copper flowers necklace here and punched out 5 flowers. (the flowers have six petals each)
2) Make triangular cut on one flower, took out a petal and then wrap it around a pearl to form the bud. Glue the pearl to the paper. keep the fifth flower aside
3) Stack 3 other flowers on the cone end of this bud, so that it looks like a flower. Glue as you go. let is rest for a while. Seal with mod podge

 Make the Chain
1) using a round nose plier (or step pliers) and eyepin, make a simple loop on a gray pearl. Repeat  for three more gray pearls, 2 big white pearls and one with a combination of gray and white pearl/bead
2) put a white pearl followed by a gray on a headpin and loop

Assembly
1) using jump rings connect the section in this order (abbv.) (JR- jump ring PB- paper bead GP- gray pearl WP- white pearl GWP – gray white pearl)

a) JR – GP – JR – PB – JR – WP – JR – PB – JR – GP (REPEAT FOR OTHER SIDE)
b) Join both in center with a JR – JR – JR – GWP – PB(CONE) – GWP

If you find the series directions confusing just look at the visual to connect them; it just sounds difficult but its really easy.
 2) Glue the rose flower on the jump rings connecting the chain and mid section and remaining flower to the back so the the rings are concealed 
3) Add chain at the back to get desired length and add a clasp if found necessary


Thats it your paper bead rose necklace is done. If you  desire you can use additional coats of sealant to protect your beads against water/sweat
I hope you find it interesting
Cheers

  1. motidana avatar

    What a nice way to use magazine paper ! I`m off to make one for myself. Thanks for sharing this lovely tutorial .

  2. Little Treasures avatar

    Love it!!
    I used to make paper beads a lot in the past – seeing this I am excited to start making them again!

  3. Anna avatar

    Beautiful…
    Have a nice weekend !
    Anna

  4. Divya N avatar

    Thanks everyone 🙂 have a great weekend

  5. Diana - FreeStyleMama avatar

    Love the flower! So pretty!!

  6. kyhfckyck avatar

    love how you have only used a few beads and how you have used pearl and paper beads

Leave a Reply

Your email address will not be published. Required fields are marked *